How to configure Access Controls for local Digium Phones

Answer

For a local Digium Phone to be able to properly locate and register to a Switchvox PBX we need to make sure the Access Controls are properly configured, follow the below steps to ensure the proper access is set:

1. Log into the /admin interface and go to Server -> Access Controls.
2. By default, All Networks entry should have all services disabled (best practice) and everything enabled for the Local Network.
3. If the phone falls under the Local Network subnet, you should be good to go. Just make sure SIP and Digium Config Server are set to On.
4. If the phone falls on a different local subnet, you will need to create a new entry for that subnet:
   1. Click Create Access Control Rule
   2. Give it a unique Rule Name
   3. Add the appropriate Network (Network must be a valid IP with CIDR notation; ie 192.168.1.0/32).
   4. I would also recommend set Never Block IPs to Yes
   5. Under Allowed Services make sure to set SIP and Digium Config Server to Yes
      1. You can also allow other Allowed Services if you would like but for Digium phones all that is required are SIP and Digium Config Server to be set to Yes
   6. Save Rule

Title

How to configure Access Controls for local Digium Phones

URL Name

How-to-configure-Access-Controls-for-local-Digium-Phones

Affected Version(s)

SMB 5.7.3;SMB 5.7.2;SMB 5.7.1.1;SMB 5.7.1;SMB 5.7.0.1;SMB 5.7;SMB 5.5.7;SMB 5.5.6;SMB 5.5.5;SMB 5.5.4;SMB 5.5.3.2;SMB 5.5.3.1;SMB 5.5.3;SMB 5.5.2;SMB 5.5